Original Housing Screws Set

€ 2,95 incl. Vat

Origineel, uit console

Past op deze moederbordrevisies

1.0: past
1.1: past
1.2: past
1.3: past
1.4: past
1.6: past
1.6b: past

Weet je niet welke je hebt? Zo zoek je het in vijf minuten uit.

Six genuine Original Xbox housing screws — the T20 Torx case screws that live under the rubber feet and the warranty label.

Condition Genuine OEM

2 in stock

Six genuine Original Xbox housing screws — the T20 Torx case screws that live under the rubber feet and the warranty label. If you’ve opened an Xbox you know how this goes: one screw was already rounded off by whoever got there first, another vanished into the carpet, and the case now sits with a lifted corner. These are factory originals, not a generic hardware-store substitute, so they thread correctly into the plastic bosses and sit flush.

Six screws is exactly one console’s worth.

What's in the box

6× genuine Original Xbox housing screws (T20 Torx)

Installation

Difficulty: Easy. Remove the four rubber feet and the two label-covered screws, swap in the new hardware, done. No soldering required. 5 minutes.

Tools: T20 Torx screwdriver (a long-shaft driver makes life much easier — the screws sit down deep recesses).

Compatibility

Fits all Original Xbox revisions — 1.0, 1.1, 1.2, 1.3, 1.4, 1.5, 1.6 and 1.6b. The case and its six screw positions were unchanged across the entire production run, including the Crystal and other limited-edition shells.